0.91inch OLED Display For Arduino White/Blue 128x32 OLED LCD IIC I2C

0.91inch OLED Display For Arduino White/Blue 128x32 OLED LCD IIC I2C

SKU:

0 review(s) | Add your review

    0

2.95 Unit(s) 2.95 USD

Product not available


Description:

  • 128×32 is a OLED Display based on SSD1306 Display controller chip. The display is mounted on an easy to solder PCB. The SSD1306 Display interfaces to microcontrollers through a I2C serial bus interface.

  • OLED Technology, Self-luminous, need no back-light (consumes less energy)

  • High resolution: 128 * 32

  • Viewing angle:> 160 degree

  • Supports various microcontrollers: Fully compatible For Raspberry Pi, Arduino, 51 Series, MSP430 Series, STM32 / 2, CSR IC, etc.

  • Ultra-low power consumption: full screen lit 0.08W

  • Operating Voltage: DC 3.3 ~5v

  • Working Temperature: :-30 ~70 celcius

  • Module Size: 38.0MM * 11.9MM * 3.9MM (excluding header height)

  • I2C/IIC Interface, needs only 2 IO pins.

  • 4.7k pull-up resistors are needed on both SDA and SCL lines.

  • Driver IC: SSD1306

  • Pixel color: White / blue

Pinouts:

  • GND

  • VCC (DC 3.3 ~5v)

  • SCL

  • SDA

Documents and Downloads:

  • SSD1306 Display Controller Datasheet

  • For Arduino Library

  • Adafruit SSD1306 library also install Adafruit GFX library

  • ARM Library

  • AVR Library

Important Note:

  • Make sure you are correctly setting the contrast value of the LCD (by writing to command register ) or you will be able to see very dim or nothing at all on the LCD.

  • When you are using u8glib, please make sure that you un-comment following statement : //U8GLIB_SSD1306_128X32 u8g(U8G_I2C_OPT_NONE|U8G_I2C_OPT_DEV_0); // I2C / TWI

  • In case of connection with NodeMCU Modules please follow following default pinouts with Adafruit library : I2C-SDA – D2/GPIO4,I2C-SCL – D1/GPIO5

Leave a comment

You must be logged in to post a comment.